If the projection is blurry, focus it by moving the phone holder either backwards or forwards.Enter a dark room and play your photo, video, or movie.Now, insert your phone holder into the projector body (making sure that the photo, video, or movie is still upside down).On that same screen, make sure your phone is at its highest setting.To lock your screen, (on a IOS device) swipe up from the bottom edge of the phone and click the Portrait Orientation Lock and if it is on, it should turn red-orange. (The photo, video, or movie should flip its view) How to Make a DIY Movie Projector in 7 Steps Prepare the box by gluing or adding duct tape to the interior of the box. First, suspend a rope from one tree to its most. Hold the phone holder with the phone attached to it, upside down. In a woodsy backyard, use the trees to create a wonderfully whimsical DIY outdoor movie screen.Open the video, photo, or movie that you want to project.(Try to tape down the edges of the phone to the holder) Tape your phone down at the center of the holder.Take your phone holder and lay it down on a flat surface.Now that you have completed the body of the projector, and the phone holder that goes into it, it is time to use it! Make sure the two rectangles together, form a right angle when looking at it from the side.Take your hot glue gun and attach the two rectangles, the longest sides touching each other.Cut the rectangles out by following the outline of the rectangles that you have drawn.(My rectangle was 2 inches by 6 3/8 inches) 2.48M subscribers 1.8M views 7 years ago Robosphere Beaming out of the Robosphere, the secret of how to make a projector out of a smartphone Try this uber cool craftpunk just in time to wow. This will be your height for the bottom support. To make the bottom support for the phone holder, use the measurement of the width, and for the height of the rectangle, divide the height of your back support rectangle by 2.(I decided to shorten (My rectangle was 4 inches by 6 3/8 inches) To make the back support for the phone holder, use your height and width to make a rectangle.Plus, it should only set you back about 5. (The height of the box was 4 3/4 inches, but I chose to make the height of the phone holder 4 inches) (Make sure to write your measurement on a piece of paper so that you may remember the measurements when making this with the cardboard) If you're tired of crowding around a laptop or smartphone to watch a movie or video clip, this DIY projector will throw it up on the wall for all to see. This time, using the ruler, measure the height of your rectangular box.(The width of mine is 6 3/8 inches) (Make sure to write this down on a piece of paper so that you may remember the measurements when making this with the cardboard) Take your ruler and measure the width of your rectangular box.
0 Comments
Leave a Reply. |